Kitchen and Bathroom Electrical Upper West Side NYC | Kitchen Remodel Wiring, Induction Cooktops & Bathroom GFCI Circuits

Code Compliant Kitchen and Bathroom Remodel Wiring

Kitchens and bathrooms demand more electrical capacity than any other part of your apartment. While a prewar kitchen originally ran on a single 15 amp circuit, a modern renovation requires multiple 20 amp countertop lines plus individual feeds for every major appliance. When you hire an Upper West Side kitchen electrician for kitchen and bathroom work, we coordinate every circuit with your general contractor and cabinet layout.

Our licensed electricians bring 3 years of experience roughing in and finishing high end apartment kitchens and bathrooms across Lincoln Square, Riverside Drive, and Central Park West. Because modern appliances need individual breaker runs, we pair remodel rough ins with dedicated circuits and panel upgrades.

Upper West Side Service Snapshot

Buildings Served Co-ops, Condos, Brownstones & Retail
Service Areas Lincoln Sq, Manhattan Valley, Morningside
ZIP Coverage 10023, 10024, 10025 & 10069
Documentation COI, Load Letters & NYC DOB Permits

Kitchen and Bathroom Electrical Work We Complete

Induction Cooktop and Wall Oven Wiring

We run heavy gauge 208 volt and 240 volt armored feeders for induction ranges, convection wall ovens, and speed ovens.

20 Amp Small Appliance Countertop Circuits

NYC code requires at least two 20 amp circuits for kitchen countertops. We space GFCI protected outlets cleanly along your backsplash and island.

Dishwasher, Disposal, and Microwave Lines

We install individual circuits and under sink disconnects for dishwashers, wine coolers, built in microwaves, and hot water dispensers.

Bathroom GFCI and Vanity Lighting

We wire dedicated 20 amp bathroom receptacle circuits, LED medicine cabinets, fog free mirror heaters, and vanity sconces.

Electric Radiant Floor Heating

We install floor warming mats, floor temperature sensors, and GFCI programmable thermostats beneath bathroom tile floors.

Exhaust Fan and Vent Hood Wiring

We wire quiet bathroom humidity sensing exhaust fans and kitchen range hoods to meet building ventilation rules.

Upper West Side Renovation Realities for Kitchens and Baths

Switching From Gas Stoves to Induction Ranges

Many Upper West Side homeowners want to replace gas stoves with induction ranges. In prewar buildings, we check whether your apartment feeder has the 40 to 50 amps required for a full induction range or if load sharing and panel upgrades are needed.

208 Volt Three Phase Power in NYC Apartment Buildings

Most Manhattan residential buildings supply 120/208 volt power rather than suburban 120/240 volt power. We verify that your chosen oven, cooktop, and dryer are rated for 208 volt operation so heating elements reach full temperature.

Wet Wall and Masonry Partition Routing

Prewar bathroom and kitchen walls often border shared plumbing wet columns and terra cotta block. We coordinate exact box depths with your tile setter and millwork drawings.

Co-op Alteration Packets and DOB Inspections

Every kitchen or bath renovation in a co-op or condo requires board approval and an NYC DOB electrical permit. We submit all required electrical filings and attend rough in and final inspections.

When to Bring Our Electricians Into Your Remodel

Bringing your licensed electrician into a kitchen or bathroom project before cabinets and tile are ordered prevents costly delays. Call us early if you are planning any of these upgrades.

You are designing a new kitchen layout and need an electrical plan showing exact outlet, appliance, and under cabinet light locations.
You want to replace a gas range with an electric or induction stove and need your apartment panel load checked.
Your existing kitchen has only one or two outlets and trips breakers whenever you use the toaster and kettle.
You are remodeling a prewar bathroom that currently has no wall outlet or only an ungrounded light socket outlet.
Your general contractor needs a licensed NYC electrical contractor to pull the DOB electrical permit for your alteration agreement.
You want heated bathroom floors, a bidet toilet seat outlet, or a lighted mirror wired inside the wall.

Heavy duty 20 amp receptacle mounted above white wood baseboard beside marble cabinetry

How Our Kitchen and Bath Remodel Process Works

Appliance Spec and Plan Review

We review your cabinet drawings and appliance specification sheets to map every circuit and box location.

Board Approval and DOB Permit

We file the NYC electrical permit and provide load calculations and insurance certificates for your co-op board.

Rough In Wiring

While walls are open, we pull armored cables from the panel, mount metal boxes, and pass rough inspection.

Trim Out and Final Testing

After tile and cabinets are installed, we mount outlets, under cabinet lights, and appliances and complete final sign off.

Kitchen and Bathroom Electrical FAQ

A typical code compliant kitchen remodel requires between 6 and 8 circuits. That includes two 20 amp countertop small appliance circuits, plus separate dedicated circuits for the refrigerator, dishwasher, microwave, range or cooktop, and kitchen lighting.

It depends on your apartment feeder amperage. If your unit has a 60 amp feeder, a standard 40 or 50 amp induction range may exceed your available load unless your riser can be upgraded or you choose a battery assisted or load managed induction unit. We check your exact riser capacity on site.

The electrical code requires at least one 20 amp GFCI protected receptacle outlet installed within 3 feet of the outside edge of each bathroom sink basin. Many homeowners also add a separate GFCI outlet near the toilet for a heated bidet seat.

Yes. We coordinate schedules with your general contractor, cabinet installer, plumber, and tile setter so rough in boxes and final fixtures align with your millwork.

Speak With Our Upper West Side Electricians

Call PeakPower Upper West Side to schedule on site electrical service for your apartment, brownstone, or commercial space.

Call (212) 555-0123

Kitchen and Bathroom Electrical in Upper West Side, NYC